Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterFast, Reliable Window Installation Across Coral Springs
Window installation in Coral Springs carries one hard rule that never bends: every unit must meet Broward County’s High Velocity Hurricane Zone code. That’s the strictest hurricane-product standard in the country, and it filters out a lot of contractors who don’t understand what they’re selling. We do. Our crews install HVHZ-certified windows throughout Coral Springs, from the Cypress Run subdivisions to the newer sections west of the Sawgrass. Call us at (850) 303-7739 and you’ll get a live person, not a recording.
We carry full Broward and Miami-Dade Notice of Acceptance paperwork on every unit we quote. No exceptions.
Why TruePane Windows & Doors Is Coral Springs’s Preferred Window Installation Company
TruePane was founded by Dale Kessler, a second-generation glazier who put a rule on the shop wall that still governs how we work in Coral Springs: if the pane is not true, the job is not done. That means the frame sits square, the sash closes flush, and the warranty gets registered in writing before our truck leaves your driveway.
Coral Springs homeowners call us for a specific reason. The housing stock here is different from what you find fifteen minutes east. Entire neighborhoods of CBS ranch homes from the 1970s and 80s are reaching the same point at the same time: original aluminum single-pane frames and jalousie louvers have hit end of life. We’ve replaced them up and down Wiles Road, near Coral Square, and through the older sections south of Sample Road. The work is consistent, the HOA approvals are familiar, and the permitting process is second nature to us.
Every technician who arrives at your Coral Springs home is background-checked and uniformed. Every quote is written side by side on paper, manufacturer against manufacturer, so you see exactly what you’re paying for. And our Done Right Promise means if the work isn’t done right, we make it right. No paperwork fights. No arguing.
Our Window Installation Services in Coral Springs
We install every type of residential window you’ll find in Coral Springs, but three styles dominate the replacement work we do here. If you live in a Coral Springs home, odds are one of these is what you need. Every quote includes the HVHZ certification path from day one, so there’s no surprise when the county inspector arrives.
Casement Windows
Casement windows are the workhorse replacement for older Coral Springs homes, especially in enclosed Florida rooms where original jalousie louvers have worn out. A casement’s crank-out operation creates a tight mechanical seal when closed, which matters in Coral Springs humidity and during the June-to-October afternoon storms. A typical casement window replacement in Coral Springs runs $650 to $1,450 per unit depending on size and glass package. If your HOA requires bronze or white anodized frames to match a Westinghouse-era streetscape, we quote that finish from the start.
Awning Windows
Awning windows hinge at the top and open outward, which makes them practical for Coral Springs rooms that stay open during light rain without letting water in. They’re common in bathrooms, kitchens, and low-profile openings where a casement won’t fit cleanly. In Coral Springs, awning window replacement typically costs $550 to $1,150 per unit, with HVHZ-certified impact glass available across the range.
Fixed & Picture Windows
Fixed windows don’t open, so they’re about glass, frame, and sealing. In Coral Springs, we regularly see original fixed units in front elevations where the aluminum frame has oxidized and the glazing bead has pulled away from years of humidity exposure. Replacement runs $400 to $900 per unit for standard sizes. Larger picture windows with custom dimensions go higher, and we quote those on a per-project basis.
Single & Double Hung Windows
Single and double hung windows remain a common sight in Coral Springs two-story CBS homes, particularly in bedrooms where code requires egress. Double hung units allow both sashes to move, which helps with airflow in Florida’s shoulder seasons. Expect to spend $600 to $1,300 per unit in Coral Springs, depending on whether you choose HVHZ-certified low-E argon-filled glass or standard impact-rated glazing.
Browse our full Window Installation offerings for more detail on these and other styles.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Coral Springs
We’re an authorized installer for more than a dozen manufacturer lines, and for Coral Springs work we lean on products that carry current Broward NOA certification. That includes Simonton, whose bronze-framed casement units have become a standard for HOA compliance in the city’s older planned subdivisions. We also install PGT and CGI impact windows frequently, because both manufacturers maintain strong HVHZ test reports and long local track records.
We quote brands side by side on paper, so you can see the price difference between a Simonton unit and a PGT unit before you commit. No surprises on the bill, period.
Common Window Installation Problems We See in Coral Springs Homes
Every city has its failure patterns. Here’s what we encounter most often in Coral Springs window work.
- Non-HVHZ “impact” windows sourced from Palm Beach County suppliers. A product legal ten miles north gets red-tagged by Broward inspectors at final inspection. The homeowner paid for a window they now have to tear out and replace. We check the NOA before we quote, never after the job is roughed in.
- HOA work-stop notices over frame color. Broward building review passes the unit, but the HOA architectural board rejects it because the finish doesn’t match the 1970s streetscape. In Coral Springs, we confirm the HOA spec before ordering anything. Bronze and white anodized aluminum are the two finishes we see approved most often.
- Water intrusion at the rough opening. Bedding an HVHZ-certified impact window into older stucco without new flashing tape invites a callback after the first afternoon thunderstorm. Coral Springs gets intense June-to-October rainfall, and aging stucco doesn’t shed water the way it did forty years ago. We rebuild the jambs and flash every opening properly.
- Gasket and seal failure in original aluminum frames. Year-round humidity breaks down old gaskets. By the time a 1970s Coral Springs aluminum window reaches replacement age, it’s often leaking air and water even before it’s removed. The fix is full replacement, not a reglaze.
Pricing for Window Installation in Coral Springs, FL
Window installation in Coral Springs runs from about $400 per unit for small fixed windows up to $1,450 or more for large casement or impact-rated units. Most whole-home replacements in the city land between $9,000 and $22,000 depending on the number of openings and the glass package. What drives cost above the base numbers: HVHZ certification (mandatory, so it’s already in our quotes), HOA-required finishes like bronze anodized aluminum, and whether the existing rough opening needs structural repair before the new unit goes in.
If your Coral Springs home still has original jalousie or single-pane aluminum windows, replacement is not optional cosmetic work. It’s required the moment you touch the opening. We’ll give you a written, line-item estimate before any work starts. Call (850) 303-7739 to schedule yours, free.
Key Takeaways
- HVHZ certification is non-negotiable in Coral Springs, even 15 miles inland.
- Original 1970s-90s aluminum and jalousie windows across the city are failing at the same time.
- HOA architectural approval matters as much as county permitting here.
- Free written estimates, fixed pricing, and both warranty layers registered in writing.
We Also Serve Cities Near Coral Springs
TruePane crews serve Coral Springs homes and the surrounding area, including Margate, Coconut Creek, Pompano Beach, and Fort Lauderdale. If you live near the Sawgrass or just across the Sample Road line, the same HVHZ-certified standards and local knowledge apply. We schedule from our South Florida office and dispatch crews from the area daily.
Serving Coral Springs, FL - Our Local Coverage Area
We’re based in the Coral Springs area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Window Installation in Coral Springs
Yes. Coral Springs sits inside Broward County’s High Velocity Hurricane Zone, which applies to the entire county regardless of distance from the coast. A window without current Miami-Dade or Broward NOA approval will be red-tagged by the building inspector. No exception. Call (850) 303-7739 if you want us to verify the product a previous contractor quoted you.
Yes. Bronze anodized aluminum frames are available with HVHZ-certified impact glazing, low-E coatings, and argon fills. Simonton and PGT both manufacture units in this finish. We coordinate with your HOA’s architectural review board before ordering, so the county inspection and the HOA sign-off happen without a work-stop notice.
In most Coral Springs homes built in the last 15 to 20 years, the window replacement itself doesn’t void the builder’s structural warranty, but improper installation that damages the rough opening, stucco, or weather barrier can. We cut and remove the old unit without disturbing the surrounding wall system, which keeps your builder warranty intact. If you’re still inside a builder warranty window, we’ll document the work in writing before we start so you have it for their records.
Jalousie windows were standard in Coral Springs homes built from the 1960s through the late 1970s, particularly in enclosed Florida rooms. They were never designed for hurricane protection, and their gaskets degrade badly in Florida humidity. Entire streets of Westinghouse-era CBS homes are reaching the same replacement point at the same time. When we pull an original jalousie unit, the gaskets are almost always hard and cracked.
The most common source is improper flashing at the rough opening, especially when the install goes into older stucco. Coral Springs homes built before the 1990s often have stucco that no longer bonds tightly to the substrate. If the new window is bedded without fresh flashing tape and proper sealant, water finds its way in during the first heavy afternoon storm. We rebuild and flash every opening as a matter of course, then water-test with a hose before we leave. Call (850) 303-7739 for an exact quote and a written scope of work. Estimates are free.
Written by Dale Kessler, Owner at TruePane Windows & Doors, serving Coral Springs and Broward County with HVHZ-certified window installation.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.