Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterCWS Door Installation in Lauderhill: What to Know First
We install, replace, and service CWS doors throughout Lauderhill as an independent CWS service provider, not a factory affiliate. Most CWS door installations run between $850 and $3,400 depending on the door type, frame condition, and whether you’re keeping the existing slab or starting fresh. Turnaround on a standard entry door is two to four days from measure to finished install. If you own a CWS door and it’s binding, sagging, or letting daylight through, call (850) 303-7739 for a straight answer and a free estimate.
This page is written for CWS homeowners in Lauderhill who want the work done correctly the first time. Dale Kessler grew up off Oakland Park Boulevard, and our techs have measured, set, and sealed doors across Broward County for decades. We know how CWS doors behave in this climate, and we don’t guess.
How CWS Products Fail - and How We Fix Them
- CWS Arched Top Entry Doors - hinge side sag from heat cycling. Lauderhill’s wet summers and dry winters make the wood frames on older CWS arched entry doors move enough that the reveal opens at the top hinge corner. The door starts to rub the threshold on the latch side. We reset the frame with shims and longer screws into the king stud, then re-square the slab. The fix holds because we address the frame, not just the hinge screws.
- CWS French Door Panels - astragal misalignment from settling. On CWS double French doors, the active panel drifts and the astragal no longer seats flush. That’s usually slab settlement and a worn top pivot, not a failed door. We re-hang the panels, replace the pivot hardware, and adjust the astragal so both panels close square. If you’ve been fighting the deadbolt for months, this is the repair you need.
- CWS Sliding Patio Doors - roller failure on aluminum tracks. Older CWS sliders in Lauderhill use steel rollers that corrode in our humidity. The door gets heavy, then the track starts to gall. We replace the rollers with sealed stainless units and service the track. If the frame is still true, that’s a $240 to $380 repair, not a full door replacement.
- CWS Impact-Rated Doors - seal compression loss after storm season. Impact doors carry a compression seal that loses memory after years of direct sun on west-facing Lauderhill exposures. You’ll feel air at the bottom corners even when the door locks tight. We install fresh compression seals and verify the door still meets the pressure rating on the spec sheet. If it doesn’t, we’ll tell you before we touch a single screw.
- CWS Custom Pivot Doors - bearing wear on oversized slabs. Oversized CWS pivot doors put all their weight on a floor pivot and a top bushing. When the top bushing wears, the door leans and scrapes the floor. We replace the bushing and pivot set, then re-balance the slab so it swings with one hand. It’s a fussy job, but it’s the difference between a door that works and one you dread opening.
Our CWS Door Installation Process
Here’s how a typical CWS door installation goes with us, from first call to final walkthrough.
- 1
Call and measure. You call (850) 303-7739. We schedule a time, show up, and measure every opening twice. CWS frames vary, and the second measurement catches what the first one misses.
- 2
Parts and options on paper. We quote OEM CWS components and quality aftermarket equivalents side by side when both exist. You see the price and warranty difference before you decide. No pressure, no surprises.
- 3
Frame prep and repair. Before the new door goes in, we true the existing frame or set a new one. Rot, settlement, and out-of-square openings get addressed here, not hidden behind trim.
- 4
Install and adjust. We set the door, shim it properly, and adjust hinges, strikes, and seals until the reveal is even and the door closes without rubbing. On impact doors, we verify the seal compression and fastener schedule before we finish.
- 5
Test and demonstrate. We operate the door ten times in front of you, lock and unlock it, and check the weather seal all the way around. If anything isn’t right, we fix it then, not later.
- 6
Warranty registration and cleanup. Both manufacturer warranty layers get registered in writing before we leave. Job site gets vacuumed. Door gets a final wipe-down. We walk the job with you before we load the truck.
What CWS Door Installation Costs in Lauderhill
Straight numbers, the way we quote on paper:
- Single CWS entry door, slab replacement in existing frame: $850-$1,400
- CWS French door install, two panels with new frame: $1,800-$3,200
- CWS sliding patio door, roller and track service: $240-$380
- CWS impact-rated entry door, full frame install: $2,200-$3,400
- CWS custom or oversized pivot door: $3,000 and up, quoted per opening
What moves the price: frame condition, whether the opening has settled, whether you need impact-rated glass, and whether the existing CWS hardware can be re-used. We don’t pad numbers with change orders. Call (850) 303-7739 for a written, line-item estimate. Quotes are free, and they tell you exactly what you’re paying for.
Why Lauderhill Homeowners Call TruePane Windows & Doors for CWS Work
We’ve been serving local communities since 2008, and TruePane was founded by Dale Kessler in 2008 to fix the specific problem of installs that were out of true and warranties that got voided on technicalities. Every CWS door we install is covered by the Done Right Promise and The Keystone Standard: both warranty layers registered in writing, durations stated, no arguing. If it isn’t done right on the first visit, we make it right.
Our techs are background-checked and uniformed. They measure twice, quote on paper, and register warranties before leaving your driveway. And because we’re an authorized installer for more than a dozen lines including, and PGT, we can show you side-by-side options when a CWS door is beyond saving or when a different product simply fits better. We work in your home the way we’d work in our own mother’s.
FAQs
No. We are an independent CWS service provider and installer. We work on CWS doors every week, and our techs know the product well, but we do not represent CWS and we don’t imply we do. What we bring is honest evaluation, straight pricing, and work that stands behind itself.
It can, if the installation isn’t done to spec. That’s why we register both warranty layers in writing before the truck leaves your driveway. If a CWS component fails and it’s under warranty, we help you file the claim and we handle the labor side correctly so the warranty isn’t voided by installation error. Call (850) 303-7739 and we’ll look up your model.
In most cases, yes. CWS uses standard handle bores and hinge patterns on their standard lines, so matching hardware is straightforward. On custom or discontinued series, we may need to source through our parts network. We’ll tell you what’s available, what the lead time is, and what the cost difference is before you commit.
Standard entry doors typically go in within two to four days of the initial measure, assuming the door and hardware are in stock locally. Custom sizes and impact-rated units take longer, usually two to three weeks. We don’t promise same-day door installation because rushing a door install is how you end up with a frame out of square and a slab that drags. If the pane is not true, the job is not done.
That depends on the frame. If the frame is sound and the slab is the problem, repair usually makes sense at $240 to $1,400 depending on what’s failed. If the frame is rotted, the threshold is failing, or the door no longer meets current impact codes for Lauderhill wind zones, replacement is the honest call. We’ll show you both options on paper and let you decide. Call (850) 303-7739 for an evaluation. If the spec sheet doesn’t back it up, we don’t say it.
Call for a Free CWS Door Installation Estimate in Lauderhill
If you’ve got a CWS door that binds, leaks, or just isn’t working the way it should, call (850) 303-7739. You’ll get a real person, a straight answer, and a free estimate with no obligation. We’ve been doing this work in Lauderhill for a long time, and we’ll still be here when you need us again.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Lauderhill and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.