Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Mr-Glass Roof Repair in Lauderhill: What to Know First
Mr-Glass roof repair in Lauderhill typically runs $350 to $1,800 depending on whether we’re replacing a single skylight seal or rebuilding the flashing and curb around a full roof glass assembly. Most jobs are completed in one visit, and we give you a written line-item quote before any work starts so there are no surprises on the bill. As an independent Mr-Glass service provider, we repair the glass, seals, frames, and flashing on Mr-Glass skylights and roof windows across Lauderhill, and we’re the call to make when the leak is inside your house and you need someone who will actually show up.
This page is for Lauderhill homeowners who own Mr-Glass roof products and need straight answers about what’s failing, what it costs, and who can fix it without pushing a full replacement that may not be necessary. Call (850) 303-7739 any time. A live person answers, day or night.
How Mr-Glass Products Fail - and How We Fix Them
We’ve worked on enough Mr-Glass roof assemblies in Lauderhill to know the failure patterns. Here’s what we actually find when we get on the roof:
- Curbside flashing separation on older Mr-Glass skylight models. The original Mr-Glass curb-mounted skylights used aluminum flashing that, after fifteen-plus years of South Florida sun and hurricane-season rain, starts to pull away at the corners where the sealant has dried out. Water gets under the flashing, runs down the curb, and shows up as a ceiling stain three feet from the skylight. We remove the old flashing, clean the curb, re-flash with new metal, and seal it with a commercial-grade urethane that moves with the roof instead of cracking.
- Condensation between the panes on Mr-Glass insulated roof glass. If you’ve got fog between the two layers of glass in a Mr-Glass roof window that’s less than ten or twelve years old, the edge seal has failed. We see this regularly in Lauderhill because the temperature swing between air-conditioned interiors and 90-degree attic heat stresses the seal bond. A failed seal means the insulating gas has escaped. We replace the glass unit and register the new seal warranty in writing before we leave.
- Frame rot on Mr-Glass wood-frame roof windows in older Lauderhill homes. Homes built in the 1970s and 1980s around the central Lauderhill neighborhoods we serve often have original wood-frame Mr-Glass roof windows. These frames wick moisture at the lower corners, rot quietly, and then start leaking during afternoon thunderstorms. We cut out the rotted section, splice in new material, and re-seal to the manufacturer’s original dimensions so the glass unit still seats properly.
- Operator mechanism failure on Mr-Glass venting roof windows. Mr-Glass venting roof windows use a chain or scissor operator that fails in two ways: stripped gears from being cranked against a stuck sash, or corrosion from the same humidity that eats the flashing. We stock replacement operators and can rebuild the mechanism without replacing the entire window, which saves you the cost of a new unit when the glass and frame are still in good shape.
- Impact glass delamination on Mr-Glass high-performance laminated units. Mr-Glass produces laminated glass for roof applications, and in Lauderhill’s sustained heat we occasionally see the interlayer start to cloud at the edges of laminated roof panels. It’s a slow failure that looks like a milky border around the glass perimeter. When that happens, the panel is no longer performing to its design spec, and we replace it with a properly matched unit rather than trying to reseal what’s already compromised.
Our Mr-Glass Roof Repair Process
Here’s how a Mr-Glass roof repair job goes when you call TruePane:
- 1
You call, we answer. A live person takes down what you’re seeing: where the water is showing up, how long it’s been happening, and the approximate age of the Mr-Glass unit. We schedule a time that works for you.
- 2
Diagnostic visit. A background-checked, uniformed technician gets on the roof and inspects the glass, frame, flashing, curb, and interior ceiling for signs of moisture migration. We photograph everything so you see what we see.
- 3
Parts decision. We determine whether the job calls for OEM Mr-Glass parts, quality aftermarket components, or a fabricated-to-spec replacement. We’ll show you the options on paper with prices side by side, and explain what each choice means for durability and warranty.
- 4
The repair. We do the work the same day when the parts are on hand, and we don’t leave a half-finished job. The area around the repair gets sealed properly, not just sealed quickly.
- 5
Testing and documentation. We water-test the repair if the job involves flashing or seals, verify that the unit operates correctly, and register any applicable warranty layers in writing before the truck leaves the driveway.
- 6
You get the bill and the promise. The price matches the quote. The work is backed by our Done Right Promise. If it’s not done right, we make it right with no paperwork fights and no arguing.
What Mr-Glass Roof Repair Costs in Lauderhill
Every Mr-Glass roof repair has its own price, and we won’t quote you a number over the phone before we’ve seen the unit. With that said, here are the ranges we see across Lauderhill:
- Single skylight seal replacement: $350 to $650
- Flashing and curb rebuild around one skylight: $600 to $1,100
- Insulated glass unit replacement for a Mr-Glass roof window: $800 to $1,800
- Full roof glass assembly replacement with new curb and flashing: $1,800 to $4,500
What moves the price is the condition of the curb underneath, whether the glass is impact-rated or standard, and whether the original flashing has to be fully dismantled to get a proper seal. You’ll get a written line-item quote before we start. Estimates are free. Call (850) 303-7739 and we’ll get you scheduled.
Why Lauderhill Homeowners Call TruePane Windows & Doors for Mr-Glass Work
We’re not the cheapest bid in Lauderhill, and we don’t try to be. We’re the company that shows up on time, does the work right, and answers the phone if something isn’t right afterward. Our Done Right Promise is simple: if it’s not done right, we make it right, no paperwork fights. Both manufacturer warranty layers get registered in writing, with durations stated, before the truck leaves your driveway. That’s The Keystone Standard, and it applies to every Mr-Glass repair we do.
Our technicians work on Mr-Glass products regularly, which means they know the failure points without guessing. When a Mr-Glass unit is beyond repair or replacement makes better financial sense, we carry lines from PGT, CGI, CWS, and ES Windows, and we’ll quote them side by side on paper so you can see exactly what you’re buying. Dale Kessler grew up off Oakland Park Boulevard, and this company has been serving Broward County with the same steady hand for decades. We’ll be here next year and the year after. That matters when you’re deciding who to trust on a roof over your head.
FAQs
We can repair it, yes, but we’re not a Mr-Glass authorized service provider, so any warranty claim goes through Mr-Glass directly and we cannot process it on your behalf. What we can do is assess the failure, document it thoroughly, and give you the evidence you need to file a claim if you’re within the warranty window. If the warranty doesn’t cover the issue or the claim process leaves you waiting, we’ll repair it and register any new warranty layers from the parts manufacturer in writing. Call (850) 303-7739 for an honest assessment of where your warranty actually stands.
Both, and we’ll show you the trade-off before you decide. OEM Mr-Glass parts guarantee dimensional match and, when applicable, preserve any remaining manufacturer warranty. Quality aftermarket parts often cost less and can match or exceed OEM specs for seals and flashing, though they don’t carry the Mr-Glass name. We quote both on paper and let you make the call with real numbers. Call (850) 303-7739 for an exact parts quote on your Mr-Glass roof assembly.
Most Mr-Glass leak repairs are completed the same day we diagnose the problem, as long as the required parts are on the truck or available locally. If the job calls for a custom-fabricated glass unit or a full curb rebuild, you’re typically looking at five to seven business days from diagnosis to completed repair. We’ll tell you the timeline on the first visit, and we’ll be there when we say. Call (850) 303-7739 to schedule an inspection.
If the frame and curb are structurally sound and the glass hasn’t delaminated, repair is usually the better investment for a Mr-Glass roof product. We’ll tell you straight if a repair will buy you three to five more quality years versus a replacement that resets the clock for fifteen or more. If replacement makes sense, we’ll quote Mr-Glass-compatible options alongside PGT, CGI, and other manufacturer lines side by side so you can compare what you’re buying. Call (850) 303-7739 and we’ll give you our honest recommendation after seeing the unit.
The price you approve on the written quote is the price you pay, unless we discover hidden damage that changes the scope of the work and you approve the change in writing first. We don’t do surprise line items on the bill. If the curb underneath a Mr-Glass skylight is rotted beyond what we could see from the surface, we’ll stop, show you the damage, and quote the additional work before we proceed. Call (850) 303-7739 to talk through what your specific repair involves. Estimates are free.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Lauderhill and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.



Before
After
Before
After
Before
After