Mr-Glass Sliding Glass & Patio Doors Nationwide | TruePane Windows & Doors

Mr-Glass Sliding Glass & Patio Doors in Lauderhill: What to Know First

We’re an independent Mr-Glass service provider in Lauderhill, and we repair and replace Mr-Glass sliding glass and patio doors all over Broward County. Most track and roller work is done in a single visit, and a full door replacement typically takes two to three weeks from measure to install. Our pricing runs mid-market: not the cheapest bid you’ll get, but a square deal with both warranty layers registered in writing before we leave your driveway. If your Mr-Glass door sticks, drags, or lets daylight through the frame, call (850) 303-7739 and a live person answers, day or night.

Call (850) 303-7739

How Mr-Glass Products Fail - and How We Fix Them

Mr-Glass doors are common in Lauderhill homes built from the late 1990s through the mid 2010s. We see the same failure patterns repeat, and we know which ones are worth fixing and which ones mean it’s time to replace the panel. Here’s what we find most often:

• Roller carrier collapse on the 7000 Series patio door. The nylon rollers on these doors were never rated for daily use over two decades of South Florida humidity. When the carrier collapses, the door drops and scrapes the track. We replace the entire carrier assembly with a stainless-steel aftermarket unit, not just the wheel, because a new wheel on an old carrier fails within a year.
• Track wear grooves that catch the door mid-slide. Aluminum tracks in Lauderhill develop deep wear lines where the roller sits, especially on doors that face west and get afternoon heat. The groove acts like a speed bump. We can often flip or shim the track on a first visit rather than replacing it, which saves hundreds on doors where the frame is still sound.
• Weep hole blockage causing frame rot at the corners. Mr-Glass door frames from the 2000s used narrow bottom tracks with small weep slots. Once those slots clog with lawn debris and sand, water sits in the track and wicks into the corner welds. We clear the weeps, treat the corrosion, and where the corner is too far gone, we quote a new panel against the same opening.
• Handle and latch misalignment after foundation settling. Lauderhill sits on a lot of fill that shifts over time. When the slab moves a fraction, the door frame racks, and the latch no longer lines up with the keeper. On Mr-Glass doors, a common fix is a frame-realignment at the header and threshold, not just bending the keeper, because bending the keeper is what leaves you with a door that locks for the kids but not for you.
• Glass seal failure in the 5000 Series. These older doors often came with dual-pane units and no low-E coating. After 20 years in Lauderhill sun, the seal fails and the glass clouds. We replace the sash with a current insulated glass unit that meets current energy code, and we register the new glass warranty before we finish the call.

Our Mr-Glass Sliding Glass & Patio Doors Process

Every Mr-Glass door gets the same method, whether it’s a roller swap or a full panel replacement. We work the way Dale Kessler learned working alongside his father off Oakland Park Boulevard, here in Lauderhill: measure everything twice, show you the numbers, and don’t leave until the door runs right. Here’s the job from call to cleanup:

1. 1
   You call. A live person answers, 24/7. We ask what the door is doing and when it started, and we book a visit that fits your schedule, not the other way around.
2. 2
   We measure and open it up. Our tech checks the track, the rollers, the frame corners, the latch, and the glass. We measure the opening twice. On Mr-Glass doors, we also check the original threshold and header because those are where the hidden wear lives.
3. 3
   We show you options on paper. If the door can be repaired, we quote the repair with OEM where possible and quality aftermarket where the OEM part was the weak point in the first place. If it needs replacing, we quote manufacturer lines side by side, in writing, with warranty durations stated.
4. 4
   We do the work. Background-checked, uniformed technicians. Drop cloths down, tracks cleaned, fasteners set to spec, and the new or repaired door run through its full travel three times before we sign off.
5. 5
   We register the warranties. Both layers, in writing, before the truck leaves the driveway. That’s The Keystone Standard.
6. 6
   You get the Done Right Promise. If the door doesn’t run right in the next 90 days, we come back and make it right. No paperwork fight, no arguing.

What Mr-Glass Sliding Glass & Patio Doors Costs in Lauderhill

Repair work on a Mr-Glass door runs from about $140 for a simple roller and track tune-up on a single panel, up to $420 when we’re replacing a full roller carrier assembly and reshimming the threshold. Recalking and weep-hole clearing usually lands between $95 and $180 as part of a visit. A new glass unit in a 5000 Series sash runs $310 to $580 depending on size and low-E spec. Full door replacement, including frame and install, typically lands between $1,800 and $3,200 in Lauderhill, and that depends on the opening size, the manufacturer line, and whether you want impact-rated glass. Call (850) 303-7739 for a free estimate with fixed, line-item pricing, and we’ll show you the numbers on paper before any work starts.

Why Lauderhill Homeowners Call TruePane Windows & Doors for Mr-Glass Work

We’ve been in this community since 2008, and the company Dale Kessler founded in 2008 was built on a simple rule: if the pane is not true, the job is not done. We hire local, train apprentices into journeymen, and we answer the phone like a company that plans to be here in thirty years, because we do. On a Mr-Glass door, that means a tech who has repaired more in the field than most people read about in a manual, and if the call ever goes beyond repair, we’re an authorized installer for more than a dozen lines, including PGT, CGI, CWS, and ES Windows. That means you get an honest recommendation, not a pitch for whatever we happen to stock. We stand behind it, in writing.

FAQs