Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
ECO Window Systems Custom & Geometric Windows in Lauderhill: What to Know First
ECO Window Systems custom and geometric windows in Lauderhill can be serviced, measured, and replaced by an independent provider, and at TruePane Windows & Doors we handle these jobs regularly. Most custom and geometric window work on ECO Window Systems products takes one to two visits, with the first visit dedicated to precise measurements and a written quote. Pricing for custom glass and frame work typically runs between $450 and $1,900 per opening depending on the window’s shape, glass pack, and whether the frame is being repaired or fully replaced. This page is for Lauderhill homeowners who own ECO Window Systems windows and want a straight answer about what is possible, what it costs, and who can do it right. Call (850) 303-7739 for a free estimate.
How ECO Window Systems Products Fail - and How We Fix Them
- Custom-shaped glass units lose their argon fill faster than rectangular units. ECO Window Systems builds geometric windows using the same insulated glass technology as their standard lines, but the angled corners and curved edges create more seal surface area relative to glass volume. When the seal at a tight radius gives out, the window fogs. We see this across Lauderhill homes with arched tops and radius corners. Our fix: we measure the exact radius, order a replacement IGU to the same curvature spec, and set it without distorting the frame.
- Frame flex on oversized openings causes the sash to bind. ECO Window Systems aluminum frames on wide custom openings, think picture windows six feet or wider, can flex under South Florida’s heat-and-cool cycles. The symptom is a window that was fine for years and then starts sticking or won’t lock cleanly. On serviced homes in Lauderhill we have found the real cause is often the header load pressing down unevenly, not a bad latch. We square the frame, reset the sash, and where needed, we reinforce the rough opening before the window goes back in.
- Weep holes on shaped windows clog faster here than on square windows. Geometric windows have more bottom-edge angles, and Lauderhill’s rain patterns plus wind-driven debris fill those small drainage channels fast. Water pools, then finds its way inside. A homeowner cannot see this from the outside. We clear the weep system, check the sill slope, and tell the homeowner what to watch for during the wet season.
- Hardware on ECO Window Systems trapezoid and pentagon units wears unevenly. The crank assemblies and hinge points on non-rectangular windows carry load at odd angles. We replace those factory hinges with OEM parts when the window is still under warranty, and with quality aftermarket hardware when it is not. The difference matters: a cheap hinge on a triangle window will bind again within two years. We won’t put that in your home.
- Flashing failures around curved window tops leak slowly and quietly. This is the one we find most on older Lauderhill homes where ECO Window Systems windows were installed as part of a renovation. The flashing at the arch doesn’t lap correctly, water gets behind the head, and by the time the homeowner sees the stain on the drywall, the damage has been happening for months. We pull the interior trim only when we must, correct the flashing from the exterior, and reseal with material rated for Broward County’s exposure.
Our ECO Window Systems Custom & Geometric Windows Process
- 1
You call (850) 303-7739. A live person answers. Not a voicemail tree. We schedule a time that works for you and we’re there when we say.
- 2
We measure twice. Every opening gets measured at multiple points with a laser and a tape. On geometric windows we template the actual shape, not just the rough opening. A quarter-inch error on a radius window means a reorder and a delay. We don’t guess.
- 3
We diagnose before we quote. Our technician opens the window, checks the hardware, inspects the seal, and tells you what is actually wrong. If it is a ol80 hinge repair and not a $900 glass replacement, we tell you that. If the spec sheet doesn’t back it up, we don’t say it.
- 4
We quote line-item on paper. OEM part versus aftermarket, glass pack options, labor, and disposal. You see exactly what you’re paying for. No surprise line items on the bill. A square deal means the number we write is the number you pay.
- 5
We do the work. Uniformed, background-checked technicians set your window, seal it, test it for plumb, level, and square. If the pane is not true, the job is not done.
- 6
We register both warranty layers before the truck leaves. That’s The Keystone Standard. Your workmanship guarantee is 90 days, in writing. We stand behind it.
What ECO Window Systems Custom & Geometric Windows Cost in Lauderhill
Most ECO Window Systems custom and geometric window work in Lauderhill falls into these ranges:
- Glass-only replacement for a geometric unit (arched, pentagon, trapezoid): $450 to $1,200
- Frame repair with new sash hardware on a custom window: $350 to $800
- Full custom window replacement, mid-size geometric unit: $900 to $1,900 per opening
- Oversized custom picture or architectural window replacement: $1,500 to $3,500
What moves the price is the glass pack, the frame material, whether we’re repairing or replacing, and how difficult the opening is to access. A second-story arch over a staircase costs more in labor than a first-floor trapezoid. We give you the exact number before any work starts, and seniors and veterans get a permanent 5% discount. Call (850) 303-7739 for a free estimate.
Why Lauderhill Homeowners Call TruePane Windows & Doors for ECO Window Systems Work
We have been serving local communities since 2008, and Dale Kessler grew up right here in Lauderhill, off Oakland Park Boulevard. He learned the trade from his father, who spent weekends caulking and reglazing windows for neighbors who could not afford to call anyone. That is the standard we work to. Every ECO Window Systems job we take is covered by the Done Right Promise: if it is not done right, we make it right, no paperwork and no arguing. Our technicians are background-checked and uniformed, and they treat your home the way they would treat their own mother’s. If your ECO Window Systems window is beyond saving and you want to compare replacement options, we are authorized installers for PGT, CGI, CWS, and ES Windows, and we will put those quotes side by side on paper so you can see exactly what you are buying.
FAQs
Yes, in most Lauderhill installations we can match your existing ECO Window Systems frame color and finish, either at the frame level when we are replacing the entire window or at the glazing bead when we are only replacing glass. We will show you a physical color sample against your existing window before we order anything. Call (850) 303-7739 and we’ll take a look.
In most cases you can replace just the insulated glass unit and keep your existing ECO Window Systems frame. We only recommend full window replacement when the frame itself is bent, rotting, or out of square beyond repair. Call (850) 303-7739 for an exact quote, the estimate is free.
We use OEM parts when your ECO Window Systems window is still under warranty, and we document every repair so you have a paper trail if you need to file a claim later. As an independent ECO Window Systems service provider, we are not authorized by the manufacturer, but we follow the same spec standards their installers use. If the workmanship ever falls short, our Done Right Promise covers it.
We template every custom shape ourselves and order directly from glass fabricators and hardware suppliers we have used for years. Typical turnaround for a custom ECO Window Systems glass unit in Lauderhill is one to two weeks from measurement to install, depending on glass pack and shape complexity. A local job should not wait on a national supply chain. Call (850) 303-7739 and we will give you a firm timeline in writing.
Most single custom or geometric window replacements are completed in one visit, typically four to six hours depending on access and frame condition. We come dressed, prepared, and ready to finish the job the same day. Call (850) 303-7739 to schedule your free estimate.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Lauderhill and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.



Before
After
Before
After
Before
After