Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterCWS Roof Replacement & Installation in Lauderhill: What to Know First
CWS roof replacement and installation in Lauderhill is work we take on as an independent CWS service provider, and most full replacements run $9,500 to $18,000 depending on roof size, pitch, and the CWS system you’re replacing. Turnaround from signed contract to finished roof is typically 5 to 9 business days once materials land, and we give you a written line-item quote before any work starts so there are no surprises on the back end. If you own a CWS roof and you’re noticing leaks, lifted seams, or flashing that’s pulling away, call us at (850) 303-7739 and we’ll send a tech who knows exactly what he’s looking at.
This page is for Lauderhill homeowners who’ve had a CWS roof for years and need straight answers about replacing it. We’ll walk through how CWS systems fail in South Florida’s heat and storm cycles, what the work actually costs, and how we handle the job from first call to final inspection.
How CWS Products Fail - and How We Fix Them
- CWS standing seam panels lifting at the lap joints. We see this most on CWS’ mechanically seamed panels after a few hurricane seasons in Lauderhill. The thermal expansion and contraction works the seams loose over time, especially on south-facing roof planes. Water gets under the seam, runs down the deck, and shows up as a ceiling stain nowhere near the actual breach. We pull the affected panels, inspect the underlayment, and reseam with the correct profile so the lap seats tight again.
- Flashing failure at roof penetrations on CWS shingle systems. CWS architectural shingles hold up well, but the pipe boots and chimney flashing are common failure points. The rubber boots crack in South Florida UV within 6 to 8 years. We replace them with UV-stable boots and proper counterflashing so water stays where it belongs.
- Valley metal corrosion on older CWS metal roofs. The valley metal CWS used on some of the early-2000s installs was thinner gauge and prone to rust-through at the low points, especially where leaves sit wet in Lauderhill’s summer downpours. We cut out the corroded section and weld in a heavier-gauge replacement, then recoat so it matches the surrounding panel finish.
- Underlayment deterioration under CWS tile profiles. If you have a CWS concrete tile roof, the tiles might look fine while the underlayment underneath is spent. We’ve pulled tiles on 25-year-old Lauderhill homes and found the felt completely dried out and cracking. That’s the hidden leak source most homeowners can’t see until water’s already in the sheathing.
- Gable trim and rake edge separation on CWS panel systems. Hurricane-force gusts work the trim screws loose, and once the rake edge lifts, wind gets under the panels and starts peeling things back. We resecure the trim with the proper fastener spacing and replace any stretched or missing screws before resealing the edge.
Our CWS Roof Replacement & Installation Process
Here’s what a typical CWS roof replacement in Lauderhill looks like when we handle it:
- 1
The call. You reach a live person, not a phone tree. We ask what you’re seeing, get your address, and schedule a site visit that works for you.
- 2
The inspection. We walk the roof, photograph everything, and trace the leak if there is one. We check the deck, the underlayment, the flashing, and the ventilation. If we find a repair that buys you another few years instead of a full replacement, we tell you that. We don’t sell a roof you don’t need.
- 3
The quote. You get a written line-item estimate with material options spelled out. We quote the CWS replacement system side by side with comparable lines from PGT, CGI, ES Windows, and ECO Window Systems where relevant so you can see exactly what you’re paying for. If the spec sheet doesn’t back it up, we don’t say it.
- 4
The work. Our background-checked, uniformed crew strips the old roof, repairs or replaces any damaged decking, installs new underlayment, and sets the new CWS system according to manufacturer spec. We pull permits and schedule inspections so everything’s on the record.
- 5
The cleanup. We magnet-sweep for nails, haul off all debris, and walk the property with you before we leave. You don’t find nails in your lawn three weeks later.
- 6
The follow-through. Every job is covered by our Done Right Promise. If it’s not done right, we make it right. No paperwork, no arguing. And our crew working in your home operates the way they would work in their own mother’s house.
What CWS Roof Replacement & Installation Costs in Lauderhill
Here are honest starting ranges for the CWS scenarios we handle most in Lauderhill:
- Full CWS shingle roof replacement (1,500-2,200 sq ft): $9,500-$14,500
- CWS standing seam metal roof replacement (1,500-2,200 sq ft): $14,000-$18,000
- CWS tile roof replacement with new underlayment (1,800-2,500 sq ft): $12,500-$16,500
- Flashing and boot replacement only (no full roof): $450-$1,200
- Valley metal repair or replacement: $600-$1,800 depending on valley length and gauge
What moves the price: roof pitch (steeper means more safety rigging and slower work), deck condition, accessibility around the property, and the specific CWS product line you’re replacing. Haul-off and permit fees are included in our quotes, not added later as change orders. Call (850) 303-7739 for an exact written estimate. Estimates are free.
Why Lauderhill Homeowners Call TruePane Windows & Doors for CWS Work
We’ve served local communities since 2008, and we’ve been replacing roofs and windows in Lauderhill long enough to know how CWS systems age here specifically. The heat, the afternoon thunderstorms, the salt air pushing inland from the coast: these things stress a roof in ways a manufacturer’s brochure never shows you. Dale Kessler grew up off Oakland Park Boulevard in Lauderhill, and the same standard applies to every CWS roof we touch: if it’s not done right, we make it right, in writing, within 90 days. No fine print. No phone tag. A live person answers our phone 24 hours a day, 7 days a week, and the tech you see on the job is background-checked, uniformed, and trained on CWS and the multi-brand backup lines we carry: PGT, CGI, ES Windows, and ECO Window Systems.
FAQs
If the work is done correctly and materials are installed to CWS spec, the manufacturer warranty on the new system applies. As an independent CWS service provider, we pull permits and schedule inspections on every full replacement so the installation is documented and defensible. Call (850) 303-7739 and we’ll walk you through what your specific CWS warranty covers.
Most full CWS roof replacements in Lauderhill run 5 to 9 business days from start to final inspection, depending on roof size, pitch, and weather. We keep you informed on the schedule so you’re not guessing when the crew arrives.
Sometimes yes. If the deck is solid and the failure is limited to flashing, boots, seams, or a section of panels, a targeted repair gets you more years at a fraction of replacement cost. We’ll tell you straight if repair makes sense. Call (850) 303-7739 for an honest assessment, free.
Yes. We pull permits on every full roof replacement and schedule the city inspection. The work is done to code, documented, and backed by our Done Right Promise.
OEM CWS parts match the exact profile and finish of the original system. Some aftermarket components are spec-compatible and cost less, but we quote both side by side in writing so you can see what you’re choosing. If the spec sheet doesn’t back it up, we don’t say it.
No. We’re an independent CWS service provider. What that means for you is we have no quota to hit and no reason to recommend a CWS product unless it’s genuinely the right fit for your Lauderhill home. If a comparable line from PGT, CGI, or another manufacturer we carry does the job better for less, we’ll say so.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Lauderhill and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.